Transverse How-To-Articles
-
Enable remote connection to Microsoft SQL Server —
Use this procedure to enable remote connection to Microsoft SQL Server.
-
2400 Simulated Lug Pulse Screen —
Use a simulated lug pulse when the site doesn't have physical lugs. This triggers a ‘lug pulse’ every few seconds to simulate a transverse system with lugs.
-
Changing Network Settings from the 2400/Inline MCU —
How to navigate and modify IP/SM settings using the 2400/Inline MCU interface.
-
Banner Photoeye Setup Procedure —
How to setup the Banner Infeed Photoeye.
-
Create SQL login authentication in Microsoft SQL Server —
Use this procedure to create a SQL login for a Microsoft SQL Server instance.
-
How to reset application if it does not start —
If a program does not start after double-clicking the icon, the user.config file may be corrupted and should be deleted.
-
Test stock hand-off on a sawmill system —
When a customer is having issues with their sorter or painter, use this to test stock handoff information, moisture sorting, and to diagnose slow PLC communication speed.
Settings will be changed during this test that will affect the outputs of the system, the stock settings, and output on time. This test will sort all lumber of one dimension as wet, and all other lumber dimensions as dry. All of the settings will need to be changed back after the test is completed.
-
Check Rx/Tx on Serial Ports —
Use this procedure to check serial communication connections.
-
Upgrading Rabbit Card —
Use this guide to install a rabbit card with new firmware.
-
Check Lug Timing —
Use this guide to determine the correct timing of the lug pulse. This requires an operator to run a single board and monitor the results.
-
Distance Calibration Procedure —
Use this guide to calibrate a distance sensor on a transverse pad.
-
Get IP Address for a local PC —
Use this guide to retrieve the IP address for a Windows PC
-
Configuring an IP/Subnet on a Controller —
Use this guide to setup the network configuration of a controller.